Throttle Position (TP) Sensor: Installation
- Position the TP sensor and install the 2 screws.
- Tighten to 3 Nm (27 lb-in).
- Install the throttle body. For additional information, refer to FUEL CHARGING AND CONTROLS .
- Connect the battery ground cable. For additional information, refer to BATTERY MOUNTING AND CABLES .
CAUTION:
Do not reuse the TP sensor and screws. A new TP sensor and screws must be installed.
CAUTION:
Do not use a high-speed driver to install the new screws or damage to the TP sensor can occur.
NOTE:
When installing the new TP sensor, make sure that the radial locator tab on the TP sensor is aligned with the radial locator hole on the throttle body.