Extension Housing Seal: Installation

NOTE: Make sure the extension housing seal is correctly installed onto the special tool and the garter spring is in the correct position.

Fig 1: Identifying Special Tool (205-115)

Courtesy of FORD MOTOR CO.

Using the special tool, install the new extension housing seal.
Using the special tools, install the output flange.

Fig 2: Identifying Special Tool (307-404) And (205-479)
Courtesy of FORD MOTOR CO.
Install a new nut.
- Tighten to 131 Nm (97 lb-ft).
  
  Fig 3: Locating Driveshaft Nut
  Courtesy of FORD MOTOR CO.
Install the driveshaft. For additional information, refer to DRIVESHAFT .
Check the transmission fluid level. For additional information, refer to TRANSMISSION FLUID LEVEL CHECK .