DTC Table
NOTE:
Some modules on this vehicle utilize a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.
DTC TABLE
| DTC | Description | Source | Action |
|---|---|---|---|
| B2477 | Module Configuration Failure | ABS module Dual Climate Controlled Seat Module (DCSM) Driver Door Module (DDM) Driver Seat Module (DSM) Parking Aid Module (PAM) Restraints Control Module (RCM) Smart Junction Box (SJB) |
CARRY OUT Programmable Module Installation (PMI). REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| B2900 | VIN Mismatch | 4X4 control module | The PCM Vehicle Identification Number (VIN) is not correct. CARRY OUT PMI for the PCM. REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| B2900 | VIN Mismatch | ABS module RCM |
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| P0602 | Powertrain Control Module Programming Error | PCM | CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| P0605 | Internal Control Module Read Only Memory (ROM ) Error | PCM | CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| P1639 | Vehicle ID Block Corrupted, Not Programmed | PCM | CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| P163E | Transmission Control Module Programming Error | PCM | CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| P163F | Transmission ID Block Corrupted, Not Programmed | PCM | CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U0300 | Internal Control Module Software Incompatibility | PCM | CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U201A:51 | Control Module Main Calibration Data: Missing Calibration | Front Controls Interface Module (FCIM) | INSTALL a new FCIM . REFER to INFORMATION AND ENTERTAINMENT SYSTEMS . |
| U201A:51 | Control Module Main Calibration Data: Missing Calibration | Audio Control Module (ACM) Audio Digital Signal Processing (DSP) module |
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U201A:54 | Control Module Main Calibration Data: Not Programmed | Headlamp Control Module 2 (HCM-2) | CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2050 | No Application Present | 4X4 control module | INSTALL a new 4X4 control module. REFER to FOUR-WHEEL DRIVE (4WD) SYSTEMS . |
| U2050 | No Application Present | ABS module DCSM DDM DSM Liftgate/Trunk Module (LTM) RCM Steering Angle Sensor Module (SASM) SJB |
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2050 | No Application Present | Occupant Classification System Module (OCSM) | INSTALL a new OCSM . REFER to REMOVAL AND INSTALLATION . |
| U2051 | One or More Calibration Files Missing/Corrupt | 4X4 control module | INSTALL a new 4X4 control module. REFER to FOUR-WHEEL DRIVE (4WD) SYSTEMS . |
| U2051 | One or More Calibration Files Missing/Corrupt | LTM | CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2051 | One or More Calibration Files Missing/Corrupt | PAM | INSTALL a new PAM . REFER to PARKING AID . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | ACM Audio DSP module HCM-2 IPC Side Obstacle Detection Control Module - Left (SOD-L) Side Obstacle Detection Control Module - Right (SOD-R) |
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | APIM | CARRY OUT APIM programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING . |
| U2100:55 | Initial Configuration Not Complete: Not Configured | Remote Function Actuator (RFA) module | CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | ACM Audio DSP module |
CARRY OUT PMI . REFER to PROGRAMMABLE MODULE INSTALLATION (PMI) . |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | APIM | CARRY OUT APIM programming. REFER to ACCESSORY PROTOCOL INTERFACE MODULE (APIM) PROGRAMMING . |
| U3000:55 | Control Module: Not Configured | HVAC module | INSTALL a new HVAC module. REFER to CLIMATE CONTROL . |