Selector Lever: Installation

Install the selector lever and the 4 selector lever bolts.
- Tighten to 10 Nm (89 lb-in).
  
  Fig 1: Locating Selector Lever Bolts
  Courtesy of FORD MOTOR CO.
Connect the electrical connector.

Fig 2: Locating Electrical Connector
Courtesy of FORD MOTOR CO.
Install the selector lever cable on the selector lever cable retainer.
- Be sure the tabs are locked in place.
  
  Fig 3: Locating Tabs And Selector Lever Cable
  Courtesy of FORD MOTOR CO.
Connect the selector lever cable end to the selector lever.

Fig 4: Locating Selector Lever Cable End Of Selector Lever
Courtesy of FORD MOTOR CO.
Install the selector lever bezel and knob. For additional information, refer to SELECTOR LEVER BEZEL and SELECTOR LEVER KNOB .
Check the selector lever cable adjustment. Make sure that the vehicle starts in PARK and NEUTRAL and the reverse lamps illuminate in REVERSE. If an adjustment is necessary, refer to SELECTOR LEVER CABLE ADJUSTMENT .