Body Control Module (BCM)
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B1175:01 | Drivers Door Ajar Switch: General Electrical Failure | GO to Pinpoint Test E . |
| B1176:01 | Passenger Door Ajar Switch: General Electrical Failure | GO to Pinpoint Test E . |
| B11C0:01 | Driver Side Rear Door Ajar Switch: General Electrical Failure | GO to Pinpoint Test E . |
| B11C1:01 | Passenger Side Rear Door Ajar Switch: General Electrical Failure | GO to Pinpoint Test E . |
| B12C2:11 | Puddle Lamp: Circuit Short To Ground | GO to Pinpoint Test D . |
| B1306:01 | Liftgate Ajar Switch: General Electrical Failure | GO to Pinpoint Test E . |
| B1313:11 | Interior Lighting Output: Circuit Short To Ground | GO to Pinpoint Test C . |
| B1313:15 | Interior Lighting Output: Circuit Short To Battery or Open | If the interior courtesy lamps are inoperative, GO to Pinpoint Test C . If the interior courtesy lamps stay on continuously, GO to Pinpoint Test F . |
| U1000:00 | Solid State Driver Protection Active - Driver Disabled: No Sub Type Information | The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The Body Control Module (BCM) cannot enable the output until the cause of the short is corrected. ADDRESS all other DTCs first. After the cause of the concern is corrected, CLEAR the DTCs. REPEAT the self-test. |
| U3000:49 | Control Module: Internal Electronic Failure | The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. The cause of the excessive current draw MUST be corrected before a new BCM is installed. ADDRESS all other DTCs first. After the cause of the concern is corrected, INSTALL a new BCM. REFER to BODY CONTROL MODULE (BCM) . TEST the system for normal operation. |
| All other DTCs | - | REFER to the Diagnostic Trouble Code (DTC) Chart in Multifunction Electronic Modules . |