Front Controls Interface Module (FCIM)
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| B00D5:01 | Restraint System Passenger Disable Indicator: General Electrical Failure | CLEAR the DTC. WAIT at least 10 seconds. REPEAT the Front Controls Interface Module (FCIM) self-test. If DTC B00D5:01 is retrieved again, INSTALL a new Front Controls Interface Module (FCIM). REFER to Front Controls Interface Module (FCIM) . |
| B113C:11 | Hazard Switch Illumination: Circuit Short To Ground | CLEAR the DTC. WAIT at least 10 seconds. REPEAT the Front Controls Interface Module (FCIM) self-test. If DTC B113C:11 is retrieved again, INSTALL a new Front Controls Interface Module (FCIM). REFER to Front Controls Interface Module (FCIM) . |
| B1202:01 | Restraint System Passenger Enable Indicator: General Electrical Failure | CLEAR the DTC. WAIT at least 10 seconds. REPEAT the Front Controls Interface Module (FCIM) self-test. If DTC B1202:01 is retrieved again, INSTALL a new Front Controls Interface Module (FCIM). REFER to Front Controls Interface Module (FCIM) . |
| U0155:00 | Lost Communication With Instrument Panel Cluster(IPC) Control Module: No Sub Type Information | GO to PINPOINT TEST AN . |
| U0423:00 | Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information | RETRIEVE and FOLLOW DTCs present in the IPC. REFER to INSTRUMENTATION, MESSAGE CENTER AND WARNING CHIMES If no DTCs are present in the IPC, DIAGNOSE the observable symptom. |
| U2013:63 | Switch Pack: Circuit/Component Protection Time-Out | GO to PINPOINT TEST AB . |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | This DTC sets due to an incorrect or incomplete FCIM configuration. Using a diagnostic scan tool, PERFORM the FCIM programming procedure using as-built data. REFER to MODULE CONFIGURATION SYSTEM for information on as-built data. |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the DTC. WAIT at least 10 seconds. REPEAT the Front Controls Interface Module (FCIM) self-test. If DTC U3000:41 is retrieved again, INSTALL a new Front Controls Interface Module (FCIM). REFER to Front Controls Interface Module (FCIM) . |
| U3000:42 | Control Module: General Memory Failure | CLEAR all CMDTCs. WAIT at least 10 seconds. RETRIEVE all CMDTCs. If DTC U3000:42 is retrieved again, INSTALL a new Front Controls Interface Module (FCIM). REFER to Front Controls Interface Module (FCIM) . |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to PINPOINT TEST AW . |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to PINPOINT TEST AX . |