Information System And Entertainment System - Am/Fm/Cd/Sync DTCS: FCIM

DTC INDEX

DTC	Description	Action
U0155:00	Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information	GO to Pinpoint Test AB .
U0257:00	Lost Communication With Front Controls/Display Interface Module: No Sub Type Information	GO to Pinpoint Test AF .
U0423:00	Invalid Data Received from Instrument Panel Cluster Control Module: No Sub Type Information	RETRIEVE and FOLLOW non-network DTCs present in the IPC. REFER to Information Center - Instrumentation, Message Center, And Warning Chimes . If no DTCs are present in the IPC, DIAGNOSE the observable symptom.
U2013:63	Switch Pack: Circuit/Component Protection Time-Out	CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC U2013:63 is retrieved again, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) .
U201A:51	Control Module Main Calibration Data: Not Programmed	This DTC sets due to incomplete or incorrect PMI procedures. CHECK vehicle service history for recent service actions related to the FCIM. If there have been recent service actions with the FCIM, INSTALL as-built data from PTS, following the diagnostic scan tool instructions under Module Programming>As-Built. If there have been no recent service actions, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) .
U3000:41	Control Module: General Checksum Failure	CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) .
U3000:42	Control Module: General Memory Failure	CLEAR the DTCs. WAIT 10 seconds. REPEAT the self-test. If DTC U3000:42 is retrieved again, INSTALL a new FCIM. REFER to Front Controls Interface Module (FCIM) .
U3003:16	Battery Voltage: Circuit Voltage Below Threshold	GO to Pinpoint Test AG .
U3003:17	Battery Voltage: Circuit Voltage Above Threshold	GO to Pinpoint Test AH .