Transfer Case Shift Motor: Installation
- 1.
Apply a small bead of silicone sealant to the transfer case shift motor mating surface.
NOTE:
New shift motor bracket nuts are loose and are tightened last. Failure to follow the steps in the correct order may result in damage to the component.
- 2.
Install the transfer case shift motor and the 3 bolts.
- Tighten to 10 Nm (89 lb-in).
- 3.
Install the transfer case shift motor bracket bolt.
- Tighten to 10 Nm (89 lb-in).
- 4.
Secure the transfer case shift motor bracket nuts.
- Tighten to 3 Nm (27 lb-in).
NOTE:
After the wire is inserted into the connector, gently pull the wire back to verify the pin is locked inside the connector.
- 5.
Insert the coil wire pin in the electrical connector and install the inner connector retainer.