Powertrain Control Module (PCM): Installation
- To install, reverse the removal procedure.
-
NOTE: This step is only necessary when installing a new component.
Upload the module information from the diagnostic tool to the module using the Programmable Modules Installation routine.
Use the General Equipment: Ford Diagnostic Equipment
- Carry out the KOEO ELCM Self? Test after programming the PCM to relearn fuel system data. Refer to the instruction manual provided by the scan tool manufacturer.
-
NOTE: The step is only necessary when installing a new component.
Carry out the Parameter Reset procedure. REFER to: Anti-Theft Key Programming - Scan Tool .