| B1305:01 |
Hood Switch: General Electrical Failure |
REFER to Anti-Theft Perimeter
. |
| C113A:11 |
Wake up Control: Circuit Short to Ground |
GO to Pinpoint Test C
. |
| C113A:15 |
Wake up Control: Circuit Short to Battery or Open |
GO to Pinpoint Test C
. |
| U1000:00 |
Solid State Driver Protection Activated - Driver Disabled: No Sub Type Information |
The BCM has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected. ADDRESS all other DTCs first. After the cause of the concern is corrected, CLEAR the DTCs. REPEAT the self-test. |
| All Other DTCs |
- |
REFER to Multifunction Electronic Modules
. |