Removal And Installation

Both sensors 

1. Remove the ACL outlet pipe and the ACL. Refer to Intake Air Distribution and Filtering .

   RH sensor 

2. Position the RH turbocharger intake tube aside. Refer to Intake Air Distribution and Filtering .

   LH sensor 

3. Position the LH turbocharger intake tube aside. Refer to Intake Air Distribution and Filtering .

   Both sensors 

4. Disconnect the CMP sensor electrical connector.
5. Remove the bolt and the CMP sensor.
   • To install, tighten to 10 Nm (89 lb-in).
6. NOTE: Lubricate the CMP sensor O-ring seal with clean engine oil.

   To install, reverse the removal procedure.