Wiper Motor

Remove wiper motor from vehicle. Connect jumper wires to connector at motor to check both speeds. For low speed, connect battery voltage to Blue wire terminal and ground the Blue/White terminal. For high speed, ground the Blue/Red terminal instead.

To check the park switch, apply battery voltage to the Blue wire terminal. Connect a jumper wire between Blue/White and Blue/Black. Ground the Black wire. Motor should run briefly and stop.

MAZDA INTERMITTENT WIPER RELAY LOCATIONS

Model

Connector

Location

GLC

Hatchback

6-pin

Left of instrument cluster

Wagon

6-pin

Right rear of engine comp.

B2000 & B2200

4-pin

Left of instrument cluster

RX7 ⁽¹⁾

17-pin

Left kick panel

626

6-pin (4 wires)

Left kick panel, top front relay

⁽¹⁾	Time delay is controlled by "Control Processing Unit".

To check rear wiper motor, apply battery voltage to Blue/Red wire and ground the Blue/White wire. Motor should run steadily.