SEV MOTOROLA Alternators: Overhaul: Disassembly

Remove drive pulley and cooling fan. Remove regulator and brush assembly. Mark front and rear housing along with stator for proper orientation during reassembly.
Remove through bolts and carefully separate front housing with rotor from rear housing with stator. Rotor may be removed from housing after bearing retaining plate screws have been removed.
NOTE: Bearings must be removed and installed using press with adaptors. Never reinstall used bearings.
Remove nuts holding diode assembly to rear housing and separate housing and stator. If diodes are faulty, complete assembly must be replaced rather than individual diodes. Use heat sink when making solder connections.