LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 1990 >> 626 Base >> Repair and Diagnosis >> Body & Frame >> Power Windows >> Removal & Installation >> Power Window Motor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Window Motor: Installation

  1. Position the motor and drive to the regulator and install the three screws snug, not tight.
  2. Connect the motor wires at the connector and cycle the glass to ensure gear engagement. After the gears are engaged, tighten the three motor and drive attaching screws to 5.6-9.6 N.m (50-84 INCH lbs).
  3. Install the door trim panel and water shield.
    NOTE: Appropriate plug buttons may be installed to cover the exposed hole at the trim panel edge, if necessary.
  4. Connect battery ground cable.
  5. Check the drain holes at the bottom of the doors to ensure that each is open to prevent water buildup over the motor.
Fig 1: Identifying Inner Door Hardware
G00134381Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals