LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 1990 >> 929 Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Testing >> Fuel Pressure (Electrical) >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Pressure (Electrical): Notes

  1. Turn ignition on. Locate fuel control unit under left side of dash. Using a jumper wire, connect terminals "B" to "D". Fuel pump (located in tank) should operate. If not, check and replace fuel pump, if necessary. Check fuel pump pressure. SeeFUEL PUMP PERFORMANCE  table.
    NOTE: Fuel pump control unit terminal identification is not available.
  2. If fuel pump operates, remove jumper wire. With ignition on, backprobe rear of fuel pump control unit. There should be 12 volts on terminals "A" and "D" only. If not, check ignition and power feed.
  3. Allow engine to idle. There should be 12 volts on terminals "A", "B", "D" and "F" only. If voltage is missing on terminal "B" only, replace fuel pump control unit. If any other terminal did not test as described, check ignition coil (tachometer signal) and power feed.
scientia non olet · About LEMON Manuals