LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 1993 >> 929 >> Repair and Diagnosis >> Body & Frame >> Power Windows >> System Tests >> Test A: All Windows Inoperative
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test A: All Windows Inoperative

  1. Turn ignition on. Check 30-amp power window fuse in fuse block, near left kick panel. If fuse is blown, replace fuse (repair wiring if necessary). If fuse is okay, measure voltage at Red/Blue wire terminal of main switch connector. If battery voltage is not present, repair Red/Blue wire between fuse and main switch.
  2. If battery voltage is present, disconnect main switch connector. Check continuity between ground and Black wire terminal of main switch connector. If continuity exists, reconnect main switch connector and go to next step. If continuity does not exist, repair Black wire between ground and main switch.
  3. Reconnect main switch connector. Measure voltage at the following wire terminals of main switch connector with main switches in specified position. If battery voltage is present at all terminals, go to next step. If battery voltage is not present at all terminals, check main switch. See MAIN SWITCH  under COMPONENT TESTS.
    • Red/Black wire (driver's switch in UP position).
    • Green/Black wire (driver's switch in DOWN position).
    • Red/White wire (main switch/passenger's in UP position).
    • Green/Red wire (main switch/passenger's in DOWN position).
    • Red/Yellow wire (main switch/left rear in UP position).
    • Green/Yellow wire (main switch/left rear in DOWN position).
    • Red/Green wire (main switch/right rear in UP position).
    • Light Green/Red wire (main switch/right rear in DOWN position).
  4. Measure voltage at the following wire terminals of sub-switch connectors with main switches in specified position. If battery voltage is present at all terminals, go to next step. If battery voltage is not present at all terminals, repair wiring between main switch and sub-switch. See WIRING DIAGRAMS  .
    • Red/White wire (main switch/passenger's in UP position).
    • Green/Red wire (main switch/passenger's in DOWN position).
    • Red/Green wire (main switch/left rear or main switch/right rear in UP position).
    • Light Green/Red wire (main switch/left rear or main switch/right rear in DOWN position).
  5. Measure voltage at the following wire terminals of sub-switch connectors with main switches in specified position. If battery voltage is present at all terminals, go to next step. If battery voltage is not present at all terminals, check sub-switch. See SUB-SWITCH  under COMPONENT TESTS.
    • Red wire (main switch/passenger, main switch/left rear or main switch/right rear in UP position).
    • Green wire (main switch/passenger, main switch/left rear or main switch/right rear in DOWN position).
  6. Measure voltage at the following wire terminals of window motor connectors with main switches in specified position. If battery voltage is present at all terminals, check window motor. See under COMPONENT TESTS. If battery voltage is not present at all terminals, repair wiring between main switch and window motor (driver's window), or between sub-switch and window motor (except driver's window).
    • Red/Black wire (driver's switch in UP position).
    • Green/Black wire (driver's switch in DOWN position).
    • Red wire (main switch/passenger, main switch/left rear or main switch/right rear in UP position).
    • Green wire (main switch/passenger, main switch/left rear or main switch/right rear in DOWN position).
scientia non olet · About LEMON Manuals