Throttle Position (TP) Sensor

NOTE: For information on connector terminal identification and test conditions specified in the following tables, see ADJUSTMENTS article in the ENGINE PERFORMANCE section.

TP SENSOR CONTINUITY

Test Condition ⁽¹⁾

⁽²⁾ Continuity

.004" (.1 mm)

Yes

.024" (.6 mm)

⁽¹⁾	Insert feeler gauge of specified thickness between throttle lever and throttle stop screw.

⁽²⁾	Check continuity with ohmmeter connected between TP sensor terminals "E" and IDL.

TP SENSOR CONTINUITY

Test Condition

Continuity Between IDL & TL/E

Continuity Between POW & TL/E

.004" (.10 mm) ⁽¹⁾

Yes

.039" (1.0 mm) ⁽¹⁾

Wide Open Throttle

Yes

⁽¹⁾	Insert feeler gauge of specified thickness between throttle lever and throttle stop screw.

TP SENSOR CONTINUITY

Test Condition ⁽¹⁾

⁽²⁾ Continuity

.006" (.15 mm)

Yes

.020" (.5 mm)

⁽¹⁾	Insert feeler gauge of specified thickness between throttle lever and throttle stop screw.

⁽²⁾	Check continuity with ohmmeter connected between TP sensor terminals "E" and IDL.