Bleeding Brake System
CAUTION:
DO NOT allow reservoir to run dry during brake bleeding procedure. If brake fluid is spilled, clean surface immediately with alcohol, as brake fluid will damage painted surfaces. Use only DOT 3 brake fluid and DO NOT mix with any other types.
- Raise and support vehicle. Ensure brake fluid reservoir remains at least half full during bleeding procedure. When bleeding brake system, start with longest brakeline first. Remove bleeder cap. Connect one end of transparent vinyl tube to bleeder screw. Submerge other end of tube in a container half filled with clean brake fluid.
- Have an assistant depress brake pedal several times and hold in depressed position. Loosen bleeder screw and drain fluid into container. Tighten bleeder screw.NOTE: Ensure brake pedal remains depressed until bleeder screw is tightened.
- Refill brake fluid reservoir if necessary. Repeat step 2) until air is no longer discharged. Tighten bleeder screw to 52-78 INCH lbs. (5.9-8.8 N.m). Ensure fluid leakage is not present. Add fluid to reservoir. Repeat procedure for remaining wheels.