Pcm Quick Test

PCM QUICK STEP INSPECTION

STEP	INSPECTION		ACTION
1	RECORD CONTINUOUS MEMORY DTC AND FREEZE FRAME DATA (FFD) Connect NGS Tester to Data Link Connector (DLC). Key ON, Engine OFF (KOEO). Retrieve all stored DTCs. Are any DTCs present?	Yes	Record all stored DTCs (Continuous Memory DTC) and Freeze Frame Data (FFD) on repair order. Go to next step.
1		No	Go to next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Check for related Service Bulletins and/or on-line repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to available repair information. If vehicle is not repaired, go to next step.
2		No	Go to next step.
3	PERFORM KEY ON, ENGINE OFF (KOEO) SELF-TEST Warm engine to normal operating temperature. Key ON, Engine OFF (KOEO). Turn off all electrical loads. Activate KOEO On Demand Self Test using NGS Tester Diagnostic Test Modes. Are any KOEO DTCs (except P1000) present?	Yes	Repair KOEO DTC. Go to applicable DTC troubleshooting procedure.
3		No	Go to next step.
4	PERFORM KEY ON, ENGINE RUNNING (KOER) SELF-TEST Key ON, Engine Running (KOER). Activate KOER On Demand Self Test using NGS Tester Diagnostic Test Modes. Are any KOER DTCs (except P1000) present?	Yes	Repair KOER DTC. Go to applicable DTC troubleshooting procedure. See DIAGNOSTIC TROUBLE CODE NUMBERS .
4		No	If Continuous Memory DTC was present at step 1, go to applicable DTC troubleshooting procedure. DIAGNOSTIC TROUBLE CODE NUMBERS . If Continuous Memory DTC was NOT present at step 1, go to symptom troubleshooting. See ENGINE SYMPTOM CHART .