LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2000 >> MPV DX >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System & Component Testing >> Fuel System >> Fuel Control >> Fuel Cut Control System (Millenia)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Cut Control System (Millenia)

  1. To check system operation, connect New Generation Star (49 T088 0A0) scan tool to Data Link Connector (DLC) No. 2. DLC 2 is located under left side of instrument panel, right of steering column. Ensure engine is at normal operating temperature. Allow engine to idle. Turn A/C switch off.
  2. Using scan tool, access DIAGNOSTIC DATA LINK menu, and select PCM. Highlight and select PID/DATA MONITOR AND RECORD. Select INJR and INJL. Scan tool will measure and display fuel injector pulse width. Increase engine speed to 4000 RPM, then quickly close throttle valve.
  3. Fuel injection pulse width should be zero milliseconds until engine speeds drops to about 1200 RPM, then pulse width should return to specification noted prior to increasing engine speed. If pulse width is as specified, A/C cutoff system is functioning properly.
  4. If pulse width is not as specified, measure voltage at PCM terminals 3Q (ECT sensor circuit), 3X (closed throttle position switch circuit), 4AH and 4AL (crankshaft position sensor circuit). See PIN VOLTAGE/PID VALUE CHARTS article. Repair as necessary.
scientia non olet · About LEMON Manuals