On-Board System Readiness (OSR) Test Mode

All OBD-II scan tools should be able to display the OSR test. The OSR will display monitors on the vehicle and status of all monitors; complete or not complete. See appropriate DRIVE CYCLES under ADDITIONAL SYSTEM FUNCTIONS . If not complete, the scan tool will display which monitor has not completed.

To enter OSR, turn ignition off. Ensure test equipment is properly attached. Program scan tool using the following steps:

• Select VEHICLE & ENGINE SELECTION menu.
• Select NEW VEHICLE, YEAR & MODEL.
• Follow operating instructions from scan tool menu.
• Select GENERIC OBD-II FUNCTIONS. Press TEST button if monitors are not complete.
• Start engine and allow to idle.
• Select ON-BOARD SYSTEM READINESS.