LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2000 >> MPV ES >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Diagnostic Tests >> DTC P0402: EGR Flow Too High >> Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0402: EGR Flow Too High: Testing

NOTE: Ensure freeze frame data has been recorded. Check for service bulletins and on-line information.
  1. Turn ignition off, then on. If no other DTCs are present, go to next step. If any other DTCs are present, repair other DTCs first.
  2. Turn ignition off. Remove EGR valve. If gasket is okay, go to next step. If gasket is faulty or not installed properly, repair as necessary. After repair, go to next step.
  3. Reconnect all components. Turn ignition on. Using scan tool, clear DTC. Start engine. Conduct Drive Mode No. 1 under DRIVE CYCLE PROCEDURE. See SELF-DIAGNOSTICS - INTRODUCTION - MIATA, MILLENIA, MPV & PROTEGE article. Check RFC FLAG PID. If FLAG is on, go to next step. If FLAG is not on, repeat Drive Mode No. 1.
  4. Conduct Drive Mode No. 2 under DRIVE CYCLE PROCEDURE. See SELF-DIAGNOSTICS - INTRODUCTION - MIATA, MILLENIA, MPV & PROTEGE article. Using scan tool on-board system readiness test function, check EGR system monitor completion status. If system has been monitored, go to next step. If system has not been monitored, repeat Drive Mode No. 2.
  5. Reconnect all components. Using scan tool diagnostic monitoring test results function, check TEST ID 10:41:00. If value is okay, go to next step. If value is not okay, replace PCM. PCM is mounted to passenger floor, behind glove box. Go to next step.
  6. Perform after repair procedure. See AFTER REPAIR PROCEDURE  . If no DTC is present, testing is complete. If any DTC is present, go to appropriate test for diagnosis and repair.
scientia non olet · About LEMON Manuals