LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2000 >> MPV ES >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System & Component Testing >> Engine Sensors & Switches >> Manifold Absolute Pressure (Map) Sensor >> Millenia 2.3L
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Millenia 2.3L

  1. MAP sensor is located in right rear of engine compartment. Connect NGS scan tool to Data Link Connector (DLC). DLC is located under left side of instrument panel, right of steering column. Turn ignition on. Using scan tool, access DIAGNOSTIC DATA LINK menu, and select PCM. Highlight and select PID/DATA MONITOR AND RECORD. Select MAP V PID.
  2. With 29.5 psi (100 kPa) of pressure applied to sensor, voltage should be 4-5 volts. With 0 psi (0 kPa) of pressure applied to sensor, voltage should be 2.3-2.8 volts. With 25.6 in. Hg of vacuum applied to sensor, voltage should be .9-1.1 volts. If all voltage readings are as specified, MAP sensor is functioning properly. If any voltage reading is not as specified, go to next step.
  3. Turn ignition off. Check continuity of circuits between MAP sensor wiring harness connector and PCM. See appropriate wiring diagram in WIRING DIAGRAMS article. If continuity exists in all circuits, go to next step. If continuity does not exist in one or more circuits, repair wiring harness as necessary.
  4. Turn ignition on. Measure voltage at terminal "B" at MAP sensor wiring harness connector. See Figure . Voltage should be 4.5-5.5 volts. Measure voltage at terminal "C" at fuel tank pressure sensor wiring harness connector. Voltage should be less than one volt. If voltage is as specified, replace MAP sensor. If voltage is not as specified, locate and repair short circuit in wiring harness. See appropriate wiring diagram in WIRING DIAGRAMS article.
scientia non olet · About LEMON Manuals