Removal & Installation

WARNING: This page is about a different car, the 2002 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

Remove the wheel and tire. Refer to WHEELS AND TIRES .
Detach the grommet from the body and pull the connector through the hole.

Fig 1: Removing Grommet
Courtesy of MAZDA MOTORS CORP.
Disconnect the sensor wiring.

Fig 2: Disconnecting Sensor Wiring
Courtesy of MAZDA MOTORS CORP.
Detach the retainer.

Fig 3: Disconnecting Sensor Wiring Retainer
Courtesy of MAZDA MOTORS CORP.
Remove the bolts.

Fig 4: Removing Bolts
Courtesy of MAZDA MOTORS CORP.

NOTE: Clean off any dirt that may have collected around the sensor before removal.

Fig 5: Removing Sensor

Courtesy of MAZDA MOTORS CORP.

Remove the bolt and the sensor.

NOTE: Thoroughly clean the mounting surface.

To install, reverse the removal procedure.