Base Removal

WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rearview mirror.
Wind each end of a wire around a bar.

Fig 1: Winding Each End Of Wire Around Bar
Courtesy of MAZDA MOTORS CORP.
WARNING:
- Using the SST (piano wire) with bare hands can cause injury. Always wear gloves when using the SST (piano wire).
NOTE:
- Use a long sawing action to spread the work over the whole length of the SST (piano wire) to prevent it from breaking.
Saw through the sealant to remove the base.