Filament Repair
WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the filament using isopropyl alcohol.
- Attach tape to both sides of the filament.
- Using a small brush or marking pen, apply silver paint.
- After 2-3 min,
carefully remove the tape without damaging the applied area.CAUTION:
- Do not operate the rear window defroster until the paint is completely dry. It may be cause other malfunctions if it is used before paint is dry.
- Dry the repaired part using the following procedure.
- When the room temperature is 25°C {77°F}, leave as it is for 24 h.
- When a hot air blower is used, dry with the temperature of 150°C {302°F} for 30 min.