LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2002 >> B4000 Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Drive Cycle Procedures >> Monitor Repair Verification Drive Cycles >> Comprehensive Component Monitor Repair Verification Drive Cycle
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Comprehensive Component Monitor Repair Verification Drive Cycle

  1. Ensure Vehicle Preparation has been performed. See OBD-II DRIVE CYCLE  . On M/T vehicles, accelerate 0-50 MPH, then stop vehicle. Go to next step. On A/T vehicles, from a stop, in overdrive, moderately accelerate to 50 MPH and cruise for at least 15 seconds. Stop vehicle and repeat without overdrive to 40 MPH and cruise for at least 30 seconds. While at 40 MPH, activate overdrive and accelerate to 50 MPH and cruise for at least 15 seconds. Stop vehicle for at least 20 seconds, then repeat this procedure 3 more times. After repeating this procedure 3 times, stop vehicle. Go to next step.
  2. Accelerate to 65 MPH. Without applying brakes, decelerate at closed throttle until vehicle reaches 40 MPH. Repeat this procedure 3 more times. After repeating this procedure 3 times, verify no DTCs are set with the exception of DTC P1000.
scientia non olet · About LEMON Manuals