Clearing Diagnostic Trouble Codes Procedure Using WDS Or Equivalent: Notes
- After repairs have been made, perform the DTCs reading procedure.
- Erase DTC by WDS or equivalent.
- Ensure that the customer's concern has been resolved.
NOTE:
After repairing the ABS wheel-speed sensor or replacing ABS/TCS HU/CM (with TCS) or ABS HU/CM (without TCS), the ABS warning light may not go off when ignition key is turned ON. In this case, start engine and drive the vehicle at a speed of more than 10 km/h {6.2 mph} until the ABS warning light goes off.