Cooling System Bleeding: 626
- Slowly pour coolant into radiator up to coolant filler port (2.0L) or into engine up to coolant filler port (2.5L).
- Add correct engine coolant mixture to reservoir until coolant level is at "F" mark. Install coolant reservoir cap.
- Fully install radiator cap (2.0L) or engine filler cap (2.5L) and coolant reservoir cap. See Figure.
- Start engine and idle for about 10 minutes.
NOTE:
If coolant temperature becomes too high, stop engine to prevent it from overheating. Repeat steps 1- 3
.
- After engine warms up, run it at about 2500 RPM for 5 minutes.
- Increase engine speed to about 3000 RPM for 5 minutes, then return to idle. Repeat several times.
- Stop engine and wait until it is cool.
- Inspect coolant level.
- Inspect for coolant leakage.