Reusing Rear Window Glass

NOTE:

Before removing the rear window glass from the body, mark the position of the glass by affixing tape to the glass and body panel.

Make a hole through the sealant, avoiding pins, from the inside of the vehicle using an awl.

Fig 1: Identifying Pin
Courtesy of MAZDA MOTORS CORP.
Pass the SST (piano wire) through the hole.
WARNING:
- Using the SST (piano wire) with bare hands can cause injury. Always wear gloves when using the SST (piano wire).
Wind each end of the SST (piano wire) around a bar.

Fig 2: Identifying Position Of Rear Window Glass Molding By Affixing Tape To Glass And Body Panel
Courtesy of MAZDA MOTORS CORP.
NOTE:
- Use a long sawing action to spread the work over the whole length of the SST (piano wire) to prevent it from breaking.
Working with another person, saw through the sealant around the edge of the glass.
Remove the rear window glass.
Remove the pins from the glass.
Remove the rear window molding from the glass.

Fig 3: Removing Sealant Around Edge Of Glass
Courtesy of MAZDA MOTORS CORP.