LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2003 >> 6 i, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls [Self-Diagnostics 2.3L] >> Programming >> Pcm Configuration
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pcm Configuration

NOTE: If PCM is replaced with a new one, PCM stores DTC P0602 and illuminates MIL even though no malfunction is detected. After completing "PCM Configuration" procedure, clear DTC P0602 using WDS or equivalent. MIL goes off after three drive cycles with no failure. (DTCs remain in PCM.)
  1. Connect WDS or equivalant to DLC-2.
  2. Set up WDS or equivalent (including vehicle recognition.
  3. Select MODULE PROGRAMMING.
  4. Select PROGRAMMABLE MODULE INSTALLATION.
  5. Select PCM and perform procedures according to directions on WDS or equivalent screen.
  6. Retrieve DTCs with WDS or equivalent, then verify there are no DTCs present. If DTC is present, perform applicable DTC inspection. Refer to DIAGNOSTIC TROUBLE CODE DEFINITIONS .
scientia non olet · About LEMON Manuals