Reusing Rear Window Glass

NOTE:

Before removing the rear window glass from the body, mark the position of the rear window glass by affixing tape to the windshield and body panel.

Use an awl to saw through the sealant, except where there are fasteners and spacers, from the inside of the vehicle.

Fig 1: Identifying Spacers And Fasteners
Courtesy of MAZDA MOTORS CORP.
Pass the SST (piano wire) through the hole.
WARNING:
- Using a SST (piano wire) with bare hands can cause injury. Always wear gloves when using a SST (piano wire).
Wind each end of the wire around a bar.

Fig 2: Applying Protective Tape
Courtesy of MAZDA MOTORS CORP.
Working with another person, saw through the sealant around the edge of the glass, being careful not to damage the body.
NOTE:
- Use a long sawing action to spread the work over the whole length of the SST (piano wire) to prevent it from breaking.
Remove the rear window glass.

Fig 3: Removing Rear Window Glass
Courtesy of MAZDA MOTORS CORP.
Remove the spacers and fasteners.
Remove the rear window molding from the rear window glass.

Fig 4: Removing Spacers And Fasteners
Courtesy of MAZDA MOTORS CORP.