Circuit Open/Short Inspection
- Disconnect the PCM connector.
- Disconnect the CPP switch connector.
- Inspect the following wiring harnesses for an open or short circuit. (Continuity inspection)
- Open circuit
- If there is no continuity in the following wiring harnesses, there is an open circuit. Repair or replace the wiring harness.
- CPP switch terminal B and PCM terminal 1O
- CPP switch terminal A and body GND
- Short circuit
- If there is continuity in the following wiring harnesses, there is a short circuit. Repair or replace the wiring harness.
- CPP switch terminal B and body GND
- CPP switch terminal B and power supply