Programming and Relearning

PCM CONFIGURATION




1. Connect the WDS or equivalent to DLC-2.
2. Set up the WDS or equivalent (including the vehicle recognition.)
3. Select "Module Programming".
4. Select "Programmable Module Installation".
5. Select "PCM" and perform procedures according to directions on the WDS or equivalent screen.

NOTE: If "PCM CONFIGURATION" is successful, the PCM stores the DTC P0602 and illuminates the MIL. (System is normal.) Clear the DTC P0602 using WDS or equivalent after "PCM CONFIGURATION."

NOTE: MIL goes off after three drive cycles with no failure. (DTCs remain in PCM.)

6. Retrieve DTC's by the WDS or equivalent, then verify that there in no DTC present.
- If DTC is present, perform applicable DTC inspection.