Volume Test
WARNING:
- Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. Always carry out the following procedure with the engine stopped.
NOTE:
- If there is an after market fuel injector tester, perform the following test.
- If there is no an after market fuel injector tester, perform "Operation Test", "Resistance Inspection", and "Fuel Leakage Test" to verify the fuel injector is okay or not.
- Complete the "BEFORE REPAIR PROCEDURE". (See BEFORE REPAIR PROCEDURE .)
- Disconnect the negative battery cable.
- Remove the fuel injectors. (See FUEL INJECTOR REMOVAL/INSTALLATION .)
- Connect the fuel injector to the fuel injector tester.
- Measure the injection volume of each fuel injector using a graduated container.
- If not a specified, replace the fuel injector.
- Injection volume
- 49-65 ml {49-65 cc, 1.7-2.1 fl oz.}/15 sec.
- Turn the ignition switch to LOCK position and disconnect the jumper wire.
- Complete the "AFTER REPAIR PROCEDURE". (See AFTER REPAIR PROCEDURE .)