Throttle Position (TP) Sweep Inspection

Connect the WDS or equivalent to the DLC-2.
Turn the ignition switch to the ON position.
Verify that none of the following DTC are displayed:
- P0122, P0123, P0222, P0223, P2101, P2106, P2107, P2108, P2109, P2112, P2119, P2122, P2123, P2127, P2128, P2135, P2136, P2138
  - If any one DTC is displayed, perform DTC inspection.
Access the TP_REL PID.
Verify that the PID reading is within the CTP value. (See ON-BOARD DIAGNOSTIC (MULTIPLEX COMMUNICATION) .)
- If the PID reading is out of range, perform the following:
  - Remove the air duct from throttle valve body.
  - Verify that the throttle valve opens when accelerator pedal is depressed.
    - If the throttle valve opens, inspect the throttle position sensor and the related wiring harness.
    - If the throttle valve does not open, inspect the throttle actuator control motor and the related wiring harness.
Gradually depress the throttle pedal and verify that the PID reading increases lineally.
- If the PID reading drops momentarily, inspect the following:
  - Throttle position sensor
Fully depress the throttle pedal and verify that the PID reading is within the WOT value. (See ON-BOARD DIAGNOSTIC (MULTIPLEX COMMUNICATION) .)
- If the PID reading is out of range, perform the following:
  - Remove the air duct from throttle valve body.
  - Verify that the throttle valve opens when throttle pedal is depressed.
    - If the throttle valve opens, inspect the throttle position sensor and the related wiring harness.
    - If the throttle valve does not open, inspect the throttle actuator control motor and the related wiring harness.