LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2005 >> 3 i, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System] >> DTC P0610 >> Diagnostic procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic procedure

DTC P0610 DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record FREEZE FRAME DATA on repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Technical Service Bulletin(s) repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to available repair information.
  • If vehicle is not repaired, go to the next step.
No Go to the next step.
3 VERIFY TROUBLESHOOTING OF DTC P0610 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Turn the ignition switch to the ON position (Engine off).
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Start the engine.
  • Is the same DTC present?
 Yes Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION .)
No Go to the next step.
4 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC troubleshooting. (See DTC TABLE )
No Troubleshooting completed.
scientia non olet · About LEMON Manuals