LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2005 >> 3 i, Standard >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System] >> DTC P0144 >> Diagnostic procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic procedure

DTC P0144 DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA AND DIAGNOSTIC MONITORING TEST RESULTS HAVE BEEN RECORDED 
  • Have FREEZE FRAME DATA and DIAGNOSTIC MONITORING TEST RESULTS (HO2S related) been recorded?
 Yes Go to the next step.
No Record the FREEZE FRAME DATA and DIAGNOSTIC MONITORING TEST RESULTS on repair order, then go to the next step.
2 VERIFY RELATED SERVICE INFORMATION AVAILABILITY 
  • Verify related Technical Service Bulletin(s) repair Information availability.
  • Is any related repair Information available?
 Yes Perform repair or diagnosis according to available Service Information.
  • If vehicle is not repaired, go to the next step.
No Go to the next step.
3 VERIFY RELATED PENDING OR STORED DTC 
  • Turn the ignition switch off, then to the ON position (Engine off).
  • Verify pending code or stored DTCs using WDS or equivalent.
  • Is other DTC present?
 Yes Go to the appropriate DTC troubleshooting procedures. (See DTC TABLE )
No Go to the next step.
4 IDENTIFY TRIGGER DTC FOR FREEZE FRAME DATA 
  • Is DTC P0144 on FREEZE FRAME DATA?
 Yes Go to the next step.
No Go to troubleshooting procedures for DTC on FREEZE FRAME DATA. (See DTC TABLE )
5 INSPECT REAR HO2S SIGNAL CIRCUIT FOR SHORT TO POWER SUPPLY 
  • Turn the ignition switch off.
  • Disconnect rear HO2S connector.
  • Turn the ignition switch to the ON position. (Engine off)
  • Measure the voltage between rear HO2S terminal A (wiring harness-side) and body ground.
  • Is any voltage reading?
 Yes Replace short to power supply, then go to Step 7.
No Go to the next step.
6 VERIFY CURRENT INPUT SIGNAL STATUS 
  • Start engine.
  • Access O2S13 PID using WDS or equivalent.
  • Verify PID while racing engine at least 10 times  in PARK (ATX) or NEUTRAL (MTX).
  • Does PID stay above 0.55 V? 
 Yes Repair or replace sensor, then go to the next step.
No Go to the next step.
7 VERIFY TROUBLESHOOTING OF DTC P0144 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Turn the ignition switch to the ON position. (Engine off)
  • Clear the DTC from the memory using the WDS or equivalent.
  • Run the PCM adaptive memory procedure drive mode and HO2S heater, HO2S, and TWC Repair Verification Drive Mode. (See OBD-II DRIVE MODE )
  • Is the PENDING CODE for this DTC present?
 Yes Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION .)
No Go to the next step.
8 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC troubleshooting. (See DTC TABLE )
No Troubleshooting completed.
scientia non olet · About LEMON Manuals