Generator Warning Light
- Verify that the battery is fully charged.
- Verify that the drive belt deflection/tension is correct. (See DRIVE BELT INSPECTION
.)
- Turn the ignition switch on and verify that the generator warning light comes on.
- If not, inspect generator warning light, wiring harnesses between the battery, generator warning light, and PCM terminal 65. When the generator warning light and the wiring harnesses are okay, replace the PCM.
- Verify that the generator warning light goes out after the engine is started.
- If not, inspect if any of the following DTCs are displayed: P0112, P0113, P2502, P2503, P2504. (See ON-BOARD DIAGNOSTIC TEST
.)