LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2005 >> MPV ES >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic (Engine Control System AJ] >> DTC P2402 >> Diagnostic procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic procedure

DTC P2402 - DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record FREEZE FRAME DATA on repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Service Bulletins and/or on line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnostic according to the available repair information.
  • If the vehicle is not repaired, then go to the next step.
No Go to the next step.
3 VERIFY RELATED PENDING CODE OR STORED DTCS 
  • Turn key to OFF then ON (Engine off).
  • Verify related pending code or stored DTCs.
  • Is DTCs P2405 present?
 Yes Go to appropriate DTC inspection.
(See DTC P2405 )
No Go to the next step.
4 CHECK EVAP SYSTEM LEAK DETECTION PUMP CIRCUIT FOR SHORT TO POWER 
  • Turn key to ON.
  • Disconnect EVAP system leak detection pump connector.
  • Measure voltage between EVAP system leak detection pump connector terminal D and body ground.
  • Is voltage B+  ?
 Yes Repair or replace wiring harness, then go to the next step.
No Go to the next step.
5 VERIFY TROUBLESHOOTING OF DTC P2402 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Start engine and warm it up completely.
  • Is same PENDING code for this DTC present?
 Yes Replace PCM, then go to the next step.
No Go to the next step.
6 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC inspection.
(See DTC TABLE .)
No Troubleshooting completed.
scientia non olet · About LEMON Manuals