Diagnostic procedure

DTC P0461 - DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has FREEZE FRAME DATA been recorded?	Yes	Go to the next step.
1		No	Record FREEZE FRAME DATA on repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Check for related Service Bulletins and/or on- line repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	INSPECT FUEL GAUGE SENDER UNIT Turn the ignition switch off. Inspect fuel gauge sender unit. (See FUEL GAUGE SENDER UNIT INSPECTION .) Is fuel gauge sender unit okay?	Yes	Replace PCM, then go to the next step.
3		No	Repair or replace fuel gauge sender unit, then go to the next step.
4	VERIFY AFTER REPAIR PROCEDURE Perform the "After Repair Procedure" (See AFTER REPAIR PROCEDURE .) Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE .)
4		No	Troubleshooting completed.