LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2005 >> MPV LX >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic (Engine Control System AJ] >> DTC P1624 >> Diagnostic procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic procedure

DTC P1624 - DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Service bulletins and/or on-line repair information availability.
  • Is any repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
2 FOLLOW OTHER DETECTED DTC FIRST 
  • Turn key to OFF and to START.
  • Has P1602 been detected?
 Yes Go to DTC P1602 inspection.
(See DTC P1602 .)
No Go to the next step.
3 INSPECT POOR CONNECTION OF IMMOBILIZER CONTROL MODULE CONNECTOR 
  • Has P1621 been detected?
 Yes Go to DTC P1621 inspection.
(See DTC P1621 .)
No Go to the next step.
4 VERIFY TROUBLESHOOTING OF DTC COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Clear the DTC from the memory using the WDS or equivalent.
  • Turn key to OFF, then start engine.
  • Is same DTC present?
 Yes Replace PCM, then go to the next step.
No Go to the next step.
5 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC inspection.
(See DTC TABLE .)
No Troubleshooting completed.
scientia non olet · About LEMON Manuals