Using the WDS or Equivalent

Using the WDS or Equivalent

NOTE:
- PIDs for the following parts are not available on this model Go to the appropriate part inspection.
- Main relay

1. Connect the WDS or equivalent to the DLC-2
2. Turn the ignition switch to ON position
3. Measure the PID value
- If PID value is not within the specification, follow the instructions in Action column

NOTE
- The PID/DATA MONITOR function monitors the calculated value of the input/output signals in the PCM Therefore, an output device malfunction is not directly indicated as a malfunction of the monitored value for the output device If a monitored value of an output device is out of specification, inspect the monitored value of the input device related to the output control
- For input/output signals except those of the monitoring items, use a voltmeter to measure the PCM terminal voltage.
- The simulation items that are used in the ENGINE CONTROL SYSTEM OPERATION INSPECTION are as follows
- ACCS, AIP RLY, ALTF, APV, ARPMDES, DEI, ETC_DSD, EVAPCP, FAN1, FAN2, FP, FPRR, FUELPW, GENVDSD, HTR11, HTR12, IASV, MOP POS, PACNTV, PREDELI, SSV, test.