Fuel Pump Operation Inspection
If simulation function of WDS or equivalent is not used:
- Connect the WDS or equivalent to the DLC-2.
- Remove the fuel-filler cap.
- Turn the ignition switch to the ON position.
- Turn the fuel pump relay from off to on using the FP PID and inspect if the operation sound of the fuel pump is heard.
- If no operation sound is heard, proceed to the next step.
- Measure the voltage at the wiring harness side fuel pump connector terminal B with the FIP PID turned on.
- If the voltage is as specified, inspect the following:
- Fuel pump continuity
- Fuel pump ground
- Wiring harness between the fuel pump relay and PCM terminal 4Q
- If not as specified, inspect the following:
- Fuel pump relay
- Fuel pump speed control relay
- Wiring harness connector (Main relay-fuel pump relay-fuel pump resister-fuel pump).
Specification
8.0-11.5 V (Ignition switch at ON)
- If the voltage is as specified, inspect the following:
If simulation function of WDS or equivalent is not used:
CAUTION:
- Connecting the wrong check connector terminal may possibly cause a malfunction. Carefully connect the specified terminal only.
- Short the check connector terminal F/P to body ground using a jumper wire.
- Remove the fuel-filler cap.
- Turn the ignition switch to the ON position.
- Verify that the fuel pump operation sound is heard.
- If no operation sound is heard, proceed to the next step.
- Measure the voltage at wiring harness side fuel pump connector terminal B.
- If the voltage is as specified, inspect the following:
- Fuel pump continuity
- Fuel pump ground
- Wiring harness between the fuel pump relay and PCM terminal, 4Q
- If not as specified, inspect the following:
- Fuel pump relay
- Fuel pump speed control relay
- Wiring harness connector (Main relay - fuel pump relay - fuel pump resister - fuel pump).
Specification
8.0-11.5 V (Ignition switch at on)
- If the voltage is as specified, inspect the following: