LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2006 >> MX-5 Miata Base >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System] >> DTC P0564 >> Diagnostic Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedure

DTC P0564 DIAGNOSTIC PROCEDURE TABLE

STEP INSPECTION ACTION
1 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
2 INSPECT CRUISE CONTROL SWITCH CONNECTOR FOR POOR CONNECTION 
  • Turn the ignition switch off.
  • Inspect for poor connection (such as damaged, pulled-out terminals, corrosion).
  • Is there any malfunction?
 Yes Repair or replace the terminal, then go to Step 6.
No Go to the next step.
3 INSPECT CRUISE CONTROL SWITCH SIGNAL CIRCUIT FOR SHORT TO GROUND 
  • Disconnect cruise control switch and PCM connectors.
  • Inspect for continuity between cruise control switch terminal B (wiring harness-side) and body ground.
  • Is there continuity?
 Yes Repair or replace short to ground, then go to Step 6.
No Go to the next step.
4 INSPECT CRUISE CONTROL SWITCH SIGNAL CIRCUIT FOR SHORT TO POWER 
  • Turn the ignition switch to the ON position (Engine off).
  • Inspect the voltage between cruise control switch terminal B (wiring harness-side) and body ground.
  • Is the voltage below 1.0 V  ?
 Yes Go to the next step.
No Repair or replace short to power supply, then go to Step 6.
5 INSPECT CRUISE CONTROL SWITCH OPERATION  Yes Go to the next step.
No Replace the cruise control switch, then go to the next step.
6 VERIFY TROUBLESHOOTING OF DTC P0564 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Drive the vehicle with cruise control 2 min. or more. 
  • Is the same DTC present?
 Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION .)
No Go to the next step.
7 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC inspection.
(See DTC TABLE  .)
No Troubleshooting completed.
scientia non olet · About LEMON Manuals