Diagnostic Procedure

DTC P1260 DIAGNOSTIC PROCEDURE TABLE

STEP	INSPECTION		ACTION
1	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
1		No	Go to the next step.
2	VERIFY STORED DTC IN INSTRUMENT CLUSTER Turn the ignition switch to the ON position (Engine off). Verify stored DTCs in instrument cluster. (See DTC INSPECTION [IMMOBILIZER SYSTEM (ADVANCED KEYLESS SYSTEM)] .) (See DTC INSPECTION [IMMOBILIZER SYSTEM (KEYLESS ENTRY SYSTEM)] .) Are DTCs stored?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [IMMOBILIZER SYSTEM (ADVANCED KEYLESS SYSTEM)] .)
2		No	Go to the next step.
3	VERIFY TROUBLESHOOTING OF DTC P1260 COMPLETED Make sure to reconnect all disconnected connectors. Clear the DTC from the PCM memory using the WDS or equivalent. Start the engine, or perform the KOEO self-test with WDS or equivalent. (See KOEO/KOER SELF TEST .) Is the same DTC present?	Yes	Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION .)
3		No	Go to the next step.
4	VERIFY AFTER REPAIR PROCEDURE Perform the "AFTER REPAIR PROCEDURE". (See AFTER REPAIR PROCEDURE .) Is any DTC present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE .)
4		No	DTC troubleshooting completed.