Diagnostic Procedure

DTC P2195 DIAGNOSTIC PROCEDURE TABLE

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA AND DIAGNOSTIC MONITORING TEST RESULTS HAVE BEEN RECORDED Have FREEZE FRAME DATA and DIAGNOSTIC MONITORING TEST RESULTS (HO2S related) been recorded?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA and DIAGNOSTIC MONITORING TEST RESULTS on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Verify related Service Bulletins and/or on-line repair information availability. Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	VERIFY RELATED PENDING CODE OR STORED DTC Turn the ignition switch off, then to ON position (Engine off). Verify the related PENDING CODE or stored DTCs. Is the DTC P2177 or P2187 also present?	Yes	Go to applicable DTC inspection. (See DTC TABLE .)
3		No	Go to the next step.
4	IDENTIFY TRIGGER DTC FOR FREEZE FRAME DATA Is DTC P2195 on FREEZE FRAME DATA?	Yes	Go to the next step.
4		No	Go to OBD-II FREEZE FRAME DATA DTC inspection. (See DTC TABLE .)
5	VERIFY CURRENT INPUT SIGNAL STATUS Connect the WDS or equivalent to the DLC-2. Verify the following PIDs. (See PCM INSPECTION .) APP1 APP2 ECT MAF TP VSS Are the PIDs normal?	Yes	Go to the next step.
5		No	Inspect the malfunctioning part according to the inspection results. Then go to Step 14.
6	VERIFY CURRENT INPUT SIGNAL STATUS UNDER FREEZE FRAME DATA CONDITION Connect the WDS or equivalent to the DLC-2. Verify the following PIDs under FREEZE FRAME DATA condition. (See PCM INSPECTION .) APP1 APP2 ECT MAF TP VSS Are the PIDs normal?	Yes	Go to the next step.
6		No	Inspect the malfunctioning part according to the inspection results. Then go to Step 14.
7	INSPECT INTAKE AIR SYSTEM FOR EXCESSIVE AIR SUCTION Visually inspect for loosen, cracks or damages hose in intake air system. Is there any malfunction?	Yes	Repair or replace the malfunctioning part, then go to Step 14.
7		No	Go to the next step.
8	VERIFY CURRENT INPUT SIGNAL STATUS OF MAF SENSOR Connect the WDS or equivalent to the DLC-2. Start the engine. Access the MAF PID. Verify that the MAF PID changes quickly according to engine speed. Is the PID normal?	Yes	Go to the next step.
8		No	Replace the MAF/IAT sensor, then go to Step 14. (See MASS AIR FLOW (MAF)/INTAKE AIR TEMPERATURE (IAT) SENSOR REMOVAL/INSTALLATION .)
9	INSPECT FRONT HO2S Inspect front HO2S. (See FRONT HEATED OXYGEN SENSOR (HO2S) INSPECTION .) Is there any malfunction?	Yes	Replace front HO2S, then go to Step 14. (See FRONT HEATED OXYGEN SENSOR (HO2S) REMOVAL/INSTALLATION .)
9		No	Go to the next step.
10	INSPECT FUEL INJECTOR Inspect fuel injector. (See FUEL INJECTOR INSPECTION .) Is there any malfunction?	Yes	Replace suspected fuel injector, then go to Step 14. (See FUEL INJECTOR REMOVAL/INSTALLATION .)
10		No	Go to the next step.
11	INSPECT FUEL LINE PRESSURE Perform the "FUEL LINE PRESSURE INSPECTION". (See FUEL LINE PRESSURE INSPECTION .) Is there any malfunction?	Yes	Go to the next step.
11		No	Go to Step 13.
12	INSPECT FUEL SYSTEM FOR FUEL LEAKAGE Visually inspect fuel leakage in the fuel system. Is there fuel leakage?	Yes	Repair or replace the malfunctioning part, then go to the next step.
12		No	Replace the fuel pump unit, then go to the next step. (See FUEL PUMP UNIT REMOVAL/INSTALLATION .)
13	VERIFY TROUBLESHOOTING OF DTC P2195 COMPLETED Make sure to reconnect all disconnected connectors. Clear the DTC from the PCM memory using the WDS or equivalent. Perform the PCM Adopted Memory Produce Drive Mode and HO2S heater, and TWC Repair Verification Drive Mode. (See OBD-II DRIVE MODE .) Is the PENDING CODE for this DTC present?	Yes	Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION .)
13		No	Go to the next step.
14	VERIFY AFTER REPAIR PROCEDURE Perform "AFTER REPAIR PROCEDURE". (See AFTER REPAIR PROCEDURE .) Is any DTC present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE .)
14		No	Troubleshooting completed.