LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2006 >> MX-5 Miata Base >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System] >> DTC P2507 >> Diagnostic Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Procedure

DTC P2507 DIAGNOSTIC PROCEDURE TABLE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT MONITOR CIRCUIT FOR SHORT TO GROUND 
  • Disconnect battery cables.
  • Inspect for continuity between battery positive terminal wiring harness-side and body ground.
  • Is there continuity?
 Yes Repair or replace the wiring harness for short to ground and install new fuse, then go to Step 6.
No Go to the next step.
4 INSPECT PCM CONNECTOR FOR POOR CONNECTION 
  • Disconnect PCM connector.
  • Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
  • Is there any malfunction?
 Yes Repair the terminals, then go to Step 6.
No Go to the next step.
5 INSPECT MONITOR CIRCUIT FOR OPEN CIRCUIT 
  • Disconnect battery cables.
  • Inspect for continuity between battery positive terminal wiring harness-side and PCM terminal 1BA (wiring harness-side).
  • Is there continuity?
 Yes Go to the next step.
No Repair or replace the wiring harness for an open circuit, then go to the next step.
6 VERIFY TROUBLESHOOTING OF DTC P2507 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Turn the ignition switch to the ON position (Engine off).
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Start the engine and warm it up completely.
  • Is the same DTC present?
 Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION .)
No Go to the next step.
7 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC inspection.
(See DTC TABLE  .)
No Troubleshooting completed.
scientia non olet · About LEMON Manuals