Active Command Modes Procedure

Active Command Modes Procedure





1. Connect the M-MDS to the DLC-2 connector.
2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
^ When using the IDS (laptop PC)
1. Select the "Toolbox" tab.
2. Select "Data Logger".
3. Select "Modules".
4. Select "TPM".
^ When using the PDS (Pocket PC)
1. Select "Module Tests".
2. Select "TPM".
3. Select "Data Logger".
3. Select the active command modes from the PID table.
4. Perform the active command modes.