DSC HU/Cm Configuration

Connect the M-MDS to the DLC-2 connector.
After the vehicle is identified, select the following items from the initial screen of the M-MDS..
- When using the IDS (laptop PC)
  1. Select the "Module Programming".
- When using the PDS (Pocket PC)
  1. Select "Programming".
  2. Select "Module Programming".
Then select the "PROGRAMMABLE MODULE INSTALLATION"and "ABS" from the screen menu.
Perform the configuration according to the directions on the screen.
Retrieve DTCs using the M-MDS, then verify that there is no DTC present.
- If any DTC is present, perform applicable DTC inspection. SeeON-BOARD DIAGNOSTIC (DYNAMIC STABILITY CONTROL) -- MAZDA6
  
  Fig 1: Locating DLC-2 Connector
  Courtesy of MAZDA MOTORS CORP.